applescript + numbers > 行または列の追加、削除。

　行または列を追加する。用語説明（shift + command + o)を参照。指定した列または行の前または後ろに列はたは行を追加できる。

　マウス操作で行うような、矩形選択した範囲のセルをドラッグアンドドロップするようなコマンドはないようだ（多分）。

--列の追加
add column after
add column before 

--列の追加
add row above
add row below

--列または行の削除
remove

範囲の選択のときに述べた通り、列を表現する方法として、column "A"、column 1、range "A"のどれでも可。

tell application "Numbers"
    activate
    if ((count of document) = 0) then
        set tgtDoc to make new document
    end if
    tell tgtDoc
        set tgtSheet to sheet 1
        tell tgtSheet
            tell table 1
                -- tabel preparation
                set header column count to 0
                set header row count to 0
                set countOfCells to count of every cell
                set i to 0
                repeat countOfCells times
                    set i to (i + 1)
                    set value of cell i to i
                end repeat
                
                -- add row or column
                add column after column "A"
                add column after range "A"
                add column after column 1
                
                add column before column "B"
                
                add row below row 1
                
                add row above row 2
                
                --romove row or column
                remove column "A"
                remove row 1

            end tell
        end tell
    end tell
end tell

translated with DeepL

　Add a row or column. See the glossary (shift + command + o). You can add a column or row before or after the specified column or row.

　There doesn't seem to be a command for dragging and dropping a rectangular selection of cells, as you would do with a mouse (maybe).

````applescript --Add column after add column after add column before 

--add column above add row above add row below

--remove column or row remove ````

As mentioned when selecting a range, you can use any of the following methods to represent a column: column "A", column 1, or range "A".